(1) ADC board on first layer
(1) ADC board on first layer |
(2) ADC board on second layer
The same set of 3 boards as on thye first layer (ADC board and 2 preamplifier boards) except rotated 180 degrees. (2) ADC board on second layer |
(3) Motor control board on third layer
(3) Motor control board on third layer |
(4) Piezo control board on fourth layer
(4) Piezo control board on fourth layer |
(5) Main control board on the fifth layer
(5) Main control board on the fifth layer |
(6) Connect boards with ribbon cable
(6) Connect boards with ribbon cable |
(8) Color code
Green = Force detector trap-A
Blue = Position detector trap-A (8) Color code |
(9) more Color Codes
Yellow = Force detector trap-B
Red = Position detector trap-B (9) more Color Codes |
(7) Attach detector cables
Plug detector cables into 8-pin headers on Preamp Boards. Position connector with red wire and blank position on top. Be carefull not to plug it upside down or offset right/left by 1 pin. Such a mistake won't damage anything, but it won't work that way. (7) Attach detector cables |