Bustamante's lab | QB3 Institute | UC Berkeley | UniPR
Assemblies: Controller Board Stack

 

Controller Board Stack

Type Instrument
Pictures
Picture
(1) ADC board on first layer

(1) ADC board on first layer
Picture
(2) ADC board on second layer
The same set of 3 boards as on thye first layer (ADC board and 2 preamplifier boards) except rotated 180 degrees.

(2) ADC board on second layer
Picture
(3) Motor control board on third layer

(3) Motor control board on third layer
Picture
(4) Piezo control board on fourth layer

(4) Piezo control board on fourth layer
Picture
(5) Main control board on the fifth layer

(5) Main control board on the fifth layer
Picture
(6) Connect boards with ribbon cable

(6) Connect boards with ribbon cable
Picture
(8) Color code
Green = Force detector trap-A Blue = Position detector trap-A

(8) Color code
Picture
(9) more Color Codes
Yellow = Force detector trap-B Red = Position detector trap-B

(9) more Color Codes
Picture
(7) Attach detector cables
Plug detector cables into 8-pin headers on Preamp Boards. Position connector with red wire and blank position on top. Be carefull not to plug it upside down or offset right/left by 1 pin. Such a mistake won't damage anything, but it won't work that way.

(7) Attach detector cables
Parents
Children main control board
Piezo driver board
Analog to Digital Converter Board
Analog to Digital Converter Board
Motor control board
Parts
NameManufacturerVendorRequiredStockCost
Ribbon cable 26 cond3M 3302/26Mouser Electronics2 ft$2.74
Ribbon Socket, 26AMP-Tyco 1658622-6DigiKey8$1.46
Spacer, Nylon1/4" diameter, 1" long, 6-32 clearanceMcMaster Carr16$0.10
Threaded Rod, SS6-32, 5"McMaster Carr4$0.88
Estimated cost: $22.28
 

List all the parts for "Controller Board Stack"

last changed 2008/11/26 23:25

Printable version