A) Mechanical parts only
A) Mechanical parts only | 
B) Mechanical parts assembled
B) Mechanical parts assembled | 
C) Circuit boards and cables
This is a picture of the detector with the DL-10 detector with its window removed and soldered in place.
C) Circuit boards and cables | 
D) PSD Holder with 2 detector boards
Shown is the DL-10 detector with window removed. To learn how to remove it, see "How to: Remove the window cover from the DL-10 detector" under Documents. Make sure to solder the detector in the proper orientation in accordance with the picture.
D) PSD Holder with 2 detector boards | 
E) PSD Holder with assembled boards
E) PSD Holder with assembled boards |
F) Detector assembly with beamsplitter cube
Non-polarizing beamsplitter cube inserted with slope toward PSD detector so reflected light goes to PSD and transmitted light goes to Iris detector (PIN 10-DI). Cube held in place with plastic-tip set screw. Get set screws from Thorlabs KM05 mirror mount where they will not be used.
F) Detector assembly with beamsplitter cube | 
G) Cube in place
Looking from this view one sees PSD and Iris detectors superposed due to half-silvered mirror.
G) Cube in place | 
H) Piece of tape blocks stray light
H) Piece of tape blocks stray light | 
I) Complete detector assy on bracket
I) Complete detector assy on bracket | 
J) Bullseye filter setup
One detector needs one bullseye filter, one disk and a cut piece of tape with 0.5" diameter hole
J) Bullseye filter setup |
Drawing
